background image

English 

8

When the timer is programmed to stop the system 
after 3 hours and start the system after 4 hours, 
the system will stop after 3 hours and then 1 hour 
later the system will start.

After the timer is programmed, the display shows 

• 

the remaining time.
Press the TIMER ON/OFF button once again to 

• 

cancel programming. The display vanishes.

OPTIMUM OPERATION

7. 

Observe the following precautions to ensure the 
system operates.

Adjust the room temperature properly for a com-

• 

fortable environment. Avoid excessive heating or 
cooling.
Prevent direct sunlight from entering a room 

• 

during cooling operation by using curtains or 
blinds.
Ventilate the room regularly.

• 

Using the unit for long periods of time requires 
attentive ventilation of the room.
Keep doors and windows closed. If the doors 

• 

and windows remain open, room air will fl ow out 
and cause to decrease the effect of cooling and 
heating.
Do not place other heaters directly below the 

• 

indoor unit.
They may deform due to the heat.
Never place objects near the air inlet and the air 

• 

outlet of the unit. It may cause deterioration in 
the effect or stop in the operation.
Turn off the main power supply switch when it is 

• 

not used for long periods of time. When the main 
power switch is turned on, some watts of elec-
tricity is being used even if the system is not 
operating. Turn off the main power supply switch 
for saving energy. When reoperating, turn on the 
main power supply switch 6 hours before opera-
tion for smooth running (Refer to “MAINTE-
NANCE”).
When the display shows “ 

• 

 ” (TIME TO 

CLEAN AIR FILTER), ask a qualifi ed service 
person to clean the fi lters (Refer to “MAINTE-
NANCE”).

MAINTENANCE

8. 

(FOR SERVICE PERSONNEL)

ONLY A QUALIFIED SERVICE PERSON IS 
ALLOWED TO PERFORM MAINTENANCE

IMPORTANT!

BEFORE OBTAINING ACCESS TO TERMINAL 

• 

DEVICES, ALL POWER SUPPLY CIRCUITS 
MUST BE INTERRUPTED

To clean the air conditioner, be sure to stop op-

• 

eration, and turn the power switch off. Otherwise, 
an electric shock and injury may result.
Do not wash the air conditioner with water.

• 

Doing so may result in an electric shock.
Be careful with a scaffold or staging.

• 

Caution must be exercised because of work at a 
high place.

HOW TO CLEAN THE AIR FILTER

Clean the air fi lter when the display shows “ 

 ” 

(TIME TO CLEAN AIR FILTER). 
Increase the frequency of cleaning if the unit is 
installed in a room where the air is extremely 
contaminated.
If the dirt becomes impossible to clean, change the 
air fi lter (Contact your dealer when you exchange 
air fi lter.).

Fig.5

Knob

Fig.6

Tab

Hook

Open the suction grille.

1. 

Slide knobs (×2) simultaneously as shown and 
then pull them downward. (Do the same proce-
dure for closing.) 

(Refer to Fig. 5)

Remove the air fi lters.

2. 

Push the 2 tabs up, and remove slowly lower 
the air fi lter. 

(Refer to Fig. 6)

01_EN_3PN07753-11N.indd   8

01_EN_3PN07753-11N.indd   8

12/19/2008   8:00:32 PM

12/19/2008   8:00:32 PM

Summary of Contents for SkyAir FHQ18PVJU
















Reviews: