Daikin OH08-1, Instruction Manual

Page: 131 / 150

OH08-1 Remote Controller (Wireless Type)
Control Systems 129
2
3PA63363-25Y-9
Continuously press the
OPERATION MODE SELECTOR button
for 4 seconds.
The displays showing “ ” of all slave indoor
unit connected to the same outdoor unit or
BS unit flash.
Press the OPERATION MODE SELEC-
TOR button to the indoor unit that you
wish to designate as the master
remote controller. Then designation is
completed. This indoor unit is desig-
nated as the master remote controller
and the display showing “
” van-
ishes.
• To change settings, repeat steps and
.
When the remote controller does not work
due to battery failure or the absence thereof,
use this switch which is located beside the
discharge grille on the main unit. When the
remote controller does not work, but the
battery low indicator on it is not lit, contact
your dealer.
[START]
To press the emergency opera-
tion switch.
The machine runs in the previous mode.
The system operates with the previously set
air flow direction.
2 MODE
EMERGENCY OPERATION
1
2
1
1 2
[STOP]
Press the EMERGENCY OPERA-
TION switch again.
This system provides two other control
systems beside individual control (one
remote controller controls one indoor unit)
system. Confirm the following if your unit is of
the following control system type.
Group control system
One remote controller controls up to 16
indoor units.
All indoor units are equally set.
Two remote controller control system
Two remote controllers control one indoor
unit. (In case of group control system, one
group of indoor units)
The unit follows individual operation.
NOTES
• Cannot have two remote controller control
system with only wireless remote
controllers. (It will be a two remote
controller control system having one wired
and one wireless remote controllers.)
• Under two remote controller control
system, wireless remote controller cannot
control timer operation.
• Only the operating indicator lamp out of 3
other lamps on the indoor unit display
functions.
NOTE
• Contact your Daikin dealer in case of
changing the combination or setting of
group control and two remote controller
control systems.
PRECAUTIONS FOR GROUP
CONTROL SYSTEM OR TWO
REMOTE CONTROLLER
CONTROL SYSTEM
2
2.7 BRC7E618 / BRC7E619