Daikin OH08-1, Instruction Manual

Page: 113 / 150

OH08-1 Remote Controller (Wireless Type)
Control Systems 111
2
C: 3PA63363-21T-6
Heating capacity & Outdoor air
temperature
• Heating capacity drops as outdoor air tem-
perature lowers. If feeling cold, use
another heater at the same time as this air
conditioner.
• Hot air is circulated to warm the room. It
will take some time from when the air con-
ditioner is first started until the entire room
becomes warm. The internal fan automat-
ically turns at low speed until the air condi-
tioner reaches a certain temperature on
the inside. In this situation, all you can do
is wait.
• If hot air accumulates on the ceiling and
feet are left feeling cold, it is recommended
to use a circulator. For details, contact the
place of purchase.
For programming TEMPERATURE, FAN
SPEED and AIR FLOW DIRECTION, follow
the procedure shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING but-
ton and program the setting tempera-
ture.
Each time this button is pressed,
setting temperature rises 1
°
C.
Each time this button is pressed,
setting temperature lowers 1
°
C.
ADJUSTMENT
DOWN
UP
DOWN
UP
In case of automatic operation
Each time this button is pressed,
setting temperature shifts to “H”
side.
Each time this button is pressed,
setting temperature shifts to “L”
side.
[
°
C]
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the
remote controller is 16˚C to 32˚C.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The microchip may sometimes control the
fan speed in order to protect the unit.
AIR FLOW DIRECTION
ADJUST
• There are 2 ways of adjusting the air dis-
charge angle.
1. A. Up and down adjustment
2. B. Left and right direction
Fig. 1
DOWN
H M L
Setting
temperature
25 23 22 21 19
FAN
SWING
A. UP AND DOWN
DIRECTION
B. LEFT AND RIGHT
DIRECTION
•
•
As the frost on the coil of an outdoor unit
increase, heating effect decreases and the
system goes into DEFROST OPERATION.
The fan operation stops and the DEFROST
lamp of the indoor unit goes on. After 6 to 8
minutes (maximum 10 minutes) of
DEFROST OPERATION, the system
returns to HEATING OPERATION.
2.6 BRC7E63W / BRC7E66