Daikin OH08-1, Instruction Manual

Page: 67 / 150

OH08-1 Remote Controller (Wireless Type)
Control Systems 65
2
„
Remote Controller Installation
NOTES
z
Do not throw the remote controller or impose large shocks. Also, do not store where it may be exposed
to moisture or direct sunlight.
z
When operating, point the transmitting part of the remote controller in the direction of the receiver.
z
The direct transmitting distance of the remote controller is approximately 7 meters.
z
The signal cannot be transmitted if something such as curtains blocks the receiver and the remote
controller.
z
When attaching in a wall or a pillar
1. Fix the remote controller holder with the screws.
2. Slide the remote controller into the remote controller holder from
the top.
z
How to insert the batteries
1. Open the back cover of the remote controller by sliding it in the
direction of the arrow.
2. Insert the attached dry cell batteries. Properly insert, set the
batteries by matching the (+) and (–) polarity marks as
indicated. Then close the cover as before.
„
Address Set Up
Determination of address and MAIN/SUB remote controller.
If setting multiple wireless remote controllers to operate in one room, perform address setting for the
receiver and the wireless remote controller.
If setting multiple wired remote controllers in one room, change the MAIN/SUB switch of the receiver.
SETTING PROCEDURE
(1) Setting the receiver
Set the wireless address switch (SS2) on the printed circuit board according to the table below.
When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller should
be set to MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.
Unit No. No. 1 No. 2 No. 3
Wireless address
switch (SS2)
MAIN SUB
MAIN/SUB switch
(SS1)
1 2 3
1 2 3
1 2 3
S
M
S
M
2.3 BRC7F634F / BRC7F635F