■
English
4
Indoor Unit Installation Diagram
CAUTION
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the INTELLIGENT EYE sensor. Also keep heating units or humidifiers outside the sensor’s
detection area.
1-3/16” (30mm) or more
from ceiling
Panel
support plate
Front panel
Intelligent eye sensor
Screw M4 × 5/8” (M4 × 16mm)*
*The 18/24 class models have 5 screws.
SSID sticker with release paper
(attached to the unit)
P
1-15/16” (50mm)
or more from walls
(on both sides)
Titanium apatite
deodorizing filter (2 pcs.)
C
A
Mounting plate
Mounting plate fixing
screw M4 × 1” (M4 × 25mm)
B
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
A
Wrap the insulation pipe
with the finishing tape from
bottom to top.
Cut thermal insulation pipe
to an appropriate length
and wrap it with tape,
making sure that no gap is
left in the insulation pipe’s
cut line.
Appearance of indoor units
may differ from some
models.
(This is a 09/12 class
illustration)
Do not connect commercially available
drain hose directly to the indoor unit.
(Water leakage may result)
Wrap with the finishing tape so that no
gap is left.
The service lid is removable.
Opening method
1) Remove the service lid
screw.
2) Pull out the service lid
horizontally in the
direction of the arrow.
3) Pull down.
Service lid
Remote controller
holder fixing screw
M3 × 13/16”
(M3 × 20mm)
F
D Wireless
remote
controller
E Remote
controller
holder
Before screwing the
remote controller holder to
the wall, make sure that
control signals are properly
received by indoor unit.
E
Screw cover*
*The 18/24 class models
have 3 screw covers.
J
Air filter
Mounting
plate
A
Hook
Mark (rear side)
Bottom
frame
Front grille
M4 × 1/2”
(M4 × 12mm)
Titanium apatite
deodorizing filter
Filter frame
Air filter
Claw
Tab
Caulk pipe hole gap with putty.
How to attach the indoor unit
Hook the hooks of the bottom frame
to the mounting plate.
If the hooks are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the hooks. If it is difficult
to release, remove the front grille.
A
01_EN_3P686877-1A.fm 4 ページ ２０２２年６月１日 水曜日 午後１２時３２分
