6 Installation
Installer reference guide
11
FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
4P518023-3F – 2019.10
a
a
a
Panel lock
3
Push the right arm lightly to the right to disconnect the shaft
from the shaft slot on the right side.
a
c
b
a
Arm
b
Shaft
c
Shaft slot
4
Disconnect the front panel shaft from the shaft slot on the left
side.
a
c
b
a
Arm
b
Shaft slot
c
Shaft
5
Remove the front panel.
6
To re-install the front panel perform the steps in the opposite
order.
6.2.4
To open the service cover
1
Remove 1 screw from the service cover.
2
Pull out the service cover horizontally away from the unit.
a
b
a
Service cover screw
b
Service cover
NOTICE
When closing the service cover, make sure that the
tightening torque does NOT exceed 1.4 (±0.2) N•m.
6.2.5
To remove the front grille
CAUTION
Wear protective gloves.
1
Open the front panel. Refer to
10].
2
Remove the service cover. Refer to
11].
3
Remove the wire harness from the wire clamp and the
connector.
4
Remove the flap by pushing it to the left side and towards you.
5
Remove the 2 screw covers using a long flat plate such as a
ruler wrapped in a cloth and remove 2 screws.
c
d
b
a
a
Connector
b
Wire clamp
c
Screw cover
d
Long flat plate wrapped in a cloth
6
Push the front grille up and then towards the mounting plate to
remove the front grille from the 3 hooks.
a
a
Hook
Prerequisite: If working space is limited.
7
Insert a flat screwdriver next to the hooks.
8
Pull the front grille up using the flat screwdriver and push
towards the mounting plate.
b
a
a
Hook
b
Flat screwdriver
6.2.6
To re-install the front grille
1
Install the front grille and firmly engage the 3 upper hooks.
2
Tighten the 2 screws and put the 2 screw covers back.
