7
GENERAL OPERATION
COOLING
1.
Press the MODE SELECTION BUTTON (24) (if required) until the COOL MODE
INDICATOR (6) is displayed.
2.
Select the desired room temperature (if required) by momentarily pressing on the top
or bottom section of the TEMPERATURE SET BUTTON (21) until the desired
temperature is displayed. Each press of the button will increase or decrease the
desired temperature by 1 degree. The desired temperature may be set in the range
of 16 - 32 degrees.
3.
Press the ON / OFF BUTTON (1) to commence operation. The OPERATION
INDICATOR (2) will illuminate.
4.
Select the desired fan speed (if required) by pressing the FAN SPEED SELECTOR
BUTTON (23).
5.
To turn the air conditioner off simply press the ON / OFF BUTTON (1). The
OPERATION INDICATOR (2) will extinguish.
HEATING
(Heat Pump Models Only)
1.
Press the MODE SELECTION BUTTON (24) (if required) until the HEAT MODE
INDICATOR (5) is displayed.
2.
Select the desired room temperature (if required) by momentarily pressing on the top
or bottom section of the TEMPERATURE SET BUTTON (21) until the desired
temperature is displayed. Each press of the button will increase or decrease the
desired temperature by 1 degree. The desired temperature may be set in the range
of 16 - 32 degrees.
3.
Press the ON / OFF BUTTON (1) to commence operation. The OPERATION
INDICATOR (2) will illuminate.
4.
Select the desired fan speed (if required) by pressing the FAN SPEED SELECTOR
BUTTON (23).
Notes: As the air conditioner incorporates a hot start system, the indoor fan will run
at an extra low (or low) speed irrespective of the selected fan speed for a few
minutes when the unit is first turned on.
During the heating mode you may notice the indoor fan changing speed.
This is due to the fan switching from the selected fan speed to extra low (or
low) when the desired room temperature is reached and the compressor
cycles off.
5.
To turn the air conditioner off simply press the ON / OFF BUTTON (1). The
OPERATION INDICATOR (2) will extinguish.
Note:
On some occasions the indoor fan will continue to run at extra low (or low)
speed for approximately one minute after the unit has been switched off.
This is not a malfunction, it is simply a function of the unit which runs the
indoor fan to remove any excess heat in the indoor unit heat exchanger.
