3
WARNING
To avoid property damage, personal injury or death, do not
use this unit if any part has been under water. Immediately
call a qualified service technician to inspect the furnace
and to replace any part of the control system and any gas
control having been under water.
WARNING
This unit must not be used as a “construction heater” during
the finishing phases of construction on a new structure.
This type of use may result in premature failure of the unit
due to extremely low return air temperature and exposure
to corrosive or very dirty atmospheres.
WARNING
To prevent the risk of property damage, personal injury, or
death, do not store combustible materials or use gasoline
or other flammable liquids or vapors in the vicinity of this
appliance.
WARNING
Do not connect to or use any device that is not design cer-
tified by the manufacturer for use with this unit. Serious
property damage, personal injury, reduced unit perfor-
mance and/or hazardous conditions may result from the use
of such non-approved devices.
WARNING
HIGH VOLTAGE!
Disconnect all power before servicing or in-
stalling this unit. Multiple power sources may
be present. Failure to do so may cause proper-
ty damage, personal injury or death.
WARNING
Connecting unit duct work to unauthorized heat producing
devices such as a fireplace insert, stove, etc. may result in
property damage, fire, carbon monoxide poisoning, explo-
sion, personal injury or death.
WARNING
This product contains or produces a chemical or chemicals
which may cause serious illness or death and which are
known to the State of California to cause cancer, birth de-
tects or other reproductive harm.
CODES AND REGULATIONS
General
The DP*HH series heat pumps are designed for
OUTDOOR USE ONLY. This series is available in cooling
Capacities of 2, 2 ½, 3, 3 ½, 4 and 5 nominal tons of
cooling. Optional field installed heat kits are available in
5,8,10,15 and 20 KW. The units can be easily installed
in manufactured or modular homes with existing high-
static duct work. The units can also be easily converted
to accommodate a plenum for normal or low-static
applications. The DP*C & DP*H series are self contained
packaged units so the only connections needed for
installation are the supply and return ducts, the line
and low voltage wiring and drain connection. Rated
performance is achieved after 20 hours of operation. Rated
performance is delivered at the specified airflow. See
outdoor unit specification sheet for split system models
or product specification sheet for packaged and light
commercial models. Specification sheets can be found at
www.goodmanmfg.com for Goodman® brand products or
www.amana-hac.com for Amana® brand products. Within
either website, please select the residential or commercial
products menu and then select the submenu for the type
of product to be installed, such as air conditioners or heat
pumps, to access a list of product pages that each contain
links to that model’s specification sheet.
EPA Regulations
IMPORTANT: The United States Environmental
Protection Agency (EPA) has issued various
regulations regarding the introduction and
disposal of refrigerants in this unit. Failure
to follow these regulations may harm the
environment and can lead to the imposition of
substantial fines. Because regulations may vary
due to passage of new laws, we suggest a certified
technician perform any work done on this unit.
Should you have any questions please contact the
local office of the EPA.
National Codes
This product is designed and manufactured to permit
installation in accordance with National Codes. It is the
installer’s responsibility to install the product in accordance
with National Codes and/or prevailing local codes and
regulations.
MAJOR COMPONENTS
General
The unit includes a hermetically sealed refrigerating system
(consisting of a compressor, condenser coil, evaporator
coil with flowrator), an indoor blower, a condenser fan and
all necessary internal electrical wiring. The heat pump also
includes a reversing valve, solenoid, defrost thermostat
and control and loss of charge protection. The system
is factory-evacuated, charged and performance tested.
Refrigerant amount and type are indicated on rating plate.
