3P257556-2A English
3
4-2 Required installation space
Install the indoor unit according to the installation manual and the following illustrations.
Indicator
Dust collection inlet
Sensor
Front side of panel
[Required installation space]
Refer to the installation instructions of the indoor unit and install the product according to the following figure.
Indoor
unit
Note 1
10°
Indoor
unit
60 (1500) or more
Exhaust
fan
Between indoor units 160 (4000) or more
Dust collection
port
From per
ipher
al equipment
10-1/8 (256)
(Note 2)
Lighting
* From wall
80 (2000) or more
10°
60 (1500) or more
60 (1500) or more (Note 3)
in. (mm)
Note:
1. A space to allow dust vacuuming is required.
2. The lighting applies to exposed models (e.g., models of inverted mountain type) and there are no restrictions on embedded models (with no
protrusion from the ceiling surface).
3. If the air discharge outlet is closed or the wind direction of the swing flaps are changed (to block the wind), the space marked with the
asterisk (*) will be 20 in. (500 mm) or over. The space will be 8 in. (200 mm) or over if the air discharge outlet with both the left and right
corners closed.
4. Refer to the operation manual provided with the remote controller for a setting method of the wind directions of the swing flap
individual
wind direction settings
.
4-3 Mounting directions of suction grille
Select one of the following mounting directions of the suction grille on the panel.
Piping
Piping
Drain
socket
Dust
collection
inlet
Drain
socket
Suction
grille
3P257556-2A.indb 3
12/16/2013 4:27:54 PM