Remote Controller (Wireless Type)
OH12-01
174
Control Systems
3P107423-1B
3
English
• How to insert the batteries
1.
Open the back cover of the remote controller by sliding it in the
direction of the arrow.
2.
Insert the attached dry cell batteries. Properly insert, set the
batteries by matching the (+) and (–) polarity marks as indi-
cated. Then close the cover as before.
4. RECEIVER INSTALLATION
(1) Preparations before installation
1.
Detach the brand name plate part of
the decoration corner panel piece,
before attaching the decoration panel.
This part is not needed hereafter.
2.
Next, remove the suction grille and the
air filter according to the instructions in
the installation manual attached to the
decoration panel.
3.
Remove the control box lid according
to the instructions in the installation
manual attached to the indoor unit.
(Be sure to turn off power, before
removing the control box lid.)
(2) Determination of address and MAIN/
SUB remote controller.
If setting multiple wireless remote control-
lers to operate in one room, perform
address setting for the receiver and the
wireless remote controller.
If setting multiple wired remote controllers
in one room, change the MAIN/SUB switch of the receiver.
SETTING PROCEDURE
1. Setting the receiver
Set the wireless address switch (SS2) on the transmitter board accord-
ing to the table below.
When using both a wired and a wireless remote controller for 1 indoor
unit, the wired controller should be set to MAIN. Therefore, set the MAIN/
SUB switch (SS1) of the transmitter board to SUB.
Unit No.
No. 1
No. 2
No. 3
Wireless address
switch (SS2)
MAIN
SUB
MAIN/SUB
switch (SS1)
Decoration panel
Brand name plate part
Push three hooks
to detach them
from the holes of
the rear side.
1 2 3
M S
SS2
SS1
1 2 3
1 2 3
1 2 3
S
M
S
M
