BRC2E52C7 / BRC3E52C7
Installation manual
4P368041-1
–
2014.02
40
Other Service Settings
17-8
Disable the Menu/Enter and Cancel
button when no other settings need
to be changed. To disable, refer to
"4-2 Enable/disable the Menu/Enter
and Cancel button" on page 12
.
● In Single setpoint mode both cooling and heating setpoints are the same. Changing one
setpoint automatically changes the other setpoint.
● In Dual setpoint mode there is always a limitation for the heating and cooling setpoint:
-
Cooling setpoint ≥ heating se minimum setpoints differential.
When the cooling setpoint is lowered below the heating se minimum setpoints
differential, the heating setpoint is automatically lowered.
-
Heating setpoint ≤ cooling setpoint – minimum setpoints differential.
When the heating setpoint is increased above the cooling setpoint – minimum setpoints
differential, the cooling setpoint is automatically increased.
NOTE
18. Other Service Settings
18-1 Group Address
● Assign the group address and unit number for centralized control.
● The group and unit address can only be set when a centralized controller is connected.
This menu is only visible when a centralized controller is connected.
● The group and unit address can be "set" and "released".
Don't forget to release the group address before disconnecting the centralized controller because
the menu will not be accesible afterwards.
NOTE
18-2 Indoor and outdoor unit Airnet Address
● Set the indoor and outdoor unit Airnet Address.
18-3 Indoor Unit Status
● Consult the indoor unit thermistor temperatures.
SkyAir
VRV
Th1
Suction air thermistor
Suction air thermistor
Th2
Heat exchanger thermistor
Heat exchanger liquid pipe thermistor
Th3
-
Heat exchanger gas pipethermistor
Th4
Discharge air thermistor
Discharge air thermistor
Th5
-
-
Th6
-
-
