Daihen OTC Welbee WB-P320E, Owner'S Manual

Page: 105 / 150

6-43
Chapter 6 W
elding Condition
S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
Example:
In the setting examples of Initial welding current: 80 A; Main welding current: 100 A; and Crater current:
60 A, the following diagram is available:
• In the following cases, this function cannot be used:
– Internal function F11 (Fine adjustment of welding conditions memory) is set to "1" to "30" (enabled);
– Internal function F44 (Reading welding condition with remote control) is set to "ON" (enabled);
– Internal function F45 (Special crater sequence) is set to "ON" (enabled);
– Internal function F48 (Adjusting current with torch switch) is set to "ON" (enabled); or
– Either of the internal functions F29 to F32 (External input terminal setting) is set to either "4" (Start) or
"5" (Loading welding condition).
6.7.2.33 F52: Data type of data log function
This function enables to select data to save when using the data log function.
The patterns of data which can be saved are as shown in the below table.
For data log function; ( 7.3
-
Data Backup (Utilization of data)).
Setting
Welding current Welding current Welding voltage Welding voltage Wire feed speed Wire feed speed
(Command
value)
(Detected value)
(Command
value)
(Detected value)
(Command
value)
(Detected value)
0 - - - - - -
1 - Storable - Storable - Storable
2 Storable - Storable - Storable -
3 Storable Storable - Storable - -
4 Storable Storable - - - Storable
5 - Storable Storable Storable - -
6 - - Storable Storable - Storable
7 - Storable - - Storable Storable
8 - - - Storable Storable Storable
100 A
80 A
60 A
100 A
60 A
Press 0.3 sec. or more
100 A
60 A
Single (within 0.3 sec.)
ON
OFF
Torch switch
Welding current
Crater-fil 㫃 Main welding
Initial condition
Crater-fil
㫃 Crater-fil
㫃
Main welding Main welding