W
ELDING
R
ESULT
C
ONTROL
F
UNCTION
A
DMINISTRATOR
F
UNCTIONS
C
HAPTER
7
7-8
When the out-of-range state becomes longer than the time specified here, an alarm displays. (
Alarm indication at the time of WARNING detection (Welding Monitor "P45" "P46"))
If "0" is set, WARNING detection will not be performed.
•
P46 (Operation at the time of WARNING detection)
Select the operation at the time of WARNING detection from 0 to 2.
The set values and operations at the time of WARNING detection are as below.
7.2.2.5
Total operation time
Total operation time and total welding time are controlled according to the setting range.
•
P50 (Cumulative total operation time)
The operation time of welding power source is counted at all time and accumulated as total operation
time.
The setting range of count value is between 0 and 999 hours. The time between 0 and 99.9 hours are
displayed in the unit of 0.1 hour and the time exceeding 100 hours is displayed in the unit of 1 hour. Refer
to P52(Clear the control data) about how to clear the "P50".
•
P51 (Cumulative total welding time)
Every interval from the start of current flowing triggered by the torch switch ON to the stop of output
triggered by the torch switch OFF is counted and accumulated as welding time.
The setting range of count value is between 0 to 999 hours, The time between 0 and 99.9 hours are
displayed in the unit of 0.1 hour and the time exceeding 100 hours is displayed in the unit of 1 hour. The
count value of "P51" will not be cleared according to the "P32" setting. Refer to P52 (Clear the control data),
about how to clear "P51".
•
P52 (Clear the control data)
Clear the various control data. After setting the setting value of P52 to "cLr", finish the "welding control"
setting with pressing the " Welding control" key for one second or more. Then, the control data shown
below will be cleared.
Set value
Operation
０
Alarm indication only. Welding can continue. (Continuous operation is possible)
1
The ongoing welding can continue.
After the welding is finished, next welding cannot start until any key of the operation panel is pressed.
(Continuous operation is not possible)
2
Welding stops immediately.
Next welding cannot start until any key of the operation panel is pressed. (Continuous operation is not possible)
P10 (Cumulative Number of welding)
P20 (Cumulative wire consumption used in welding)
P30 (Cumulative total welding time)
P50 (Cumulative total operation time)
P51 (Cumulative total welding time)
