M
EMORY
F
UNCTION
OF
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-12
3.
Press the ENTER key.
4.
Press the ENTER key.
⇒
The welding condition is registered with the selected JOB No., and the read mode is terminated.
The selected position on the operation panel and the current/voltage values are overwritten to those
read out.
6.5.3
Deletion of memory registration
This section explains how to delete the welding conditions registered to the memory.
NOTE
• The deleted data cannot be restored. Before deleting the stored welding condition, carefully
check the welding JOB No. to delete.
1.
Turn off the power switch.
2.
With the LOAD key and the SAVE key depressed together, turn ON the power switch.
⇒
The LED of ENTER key flashes.
⇒
Pressing the DISPLAY CHANGE key enables to
check the set values of welding conditions (welding
parameters) to read out. The setting values are
displayed on the left/right digital meters in a
flashing mode.
⇒
To change the JOB No. to read out, press the LOAD
key. The display returns to the status described in
step 1.
⇒
To cancel the read out, press the SAVE key. The read
mode is terminated.
●
Depress these two keys until "dEL" is displayed on
the left digital meter. Release the keys after "dEL" is
displayed.
⇒
"dEL" is displayed when the system transits to the
DELETE mode.
⇒
The JOB No. (registration No.) is displayed on the
right digital meter in a flashing mode, and the LED
of JOB No. lights up.
ENTER
㧔
3 sec.
㧕
ENTER
㧔
3 sec.
㧕
A
V
r
㧑
ON
+
WARNING
m/min.
sec.
JOB No.
LOAD
SAVE
Hz
