6-13
Chapter 6
W
elding Condition
S
ETTING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
3.
Turn the parameter adjustment knob, and select the JOB No. to delete.
4.
Press the ENTER key.
5.
Press the ENTER key.
6.
Check that "End" is displayed on the left/right digital meters and turn off the power switch.
⇒
The power LED switch lights off. The status returns to normal when the power switch is turned on.
6.6 Setting Welding Conditions
This section explains how to set the welding conditions (welding mode or welding parameters).
6.6.1
Welding mode setting
Available combination of the welding mode is listed in the table below. Selecting unavailable
combination displays “- - -“ on the right/left digital meter in a flashing mode.
Standard specification
●
To delete all the registration at the same time, turn
the parameter adjustment knob counterclockwise, to
display "ALL" on the right digital meter.
When "ALL" is selected, the current welding
condition set on the operation panel is also deleted,
and the welding parameters including the internal
functions return to the initial values.
⇒
The display "dEL" on the left digital meter starts
flashing.
⇒
Pressing the DISPLAY CHANGE key enables to
check the value of welding parameter of the JOB No.
to delete. The set values are displayed on the left/
right digital meters in a flashing mode.
⇒
To change the JOB No. to delete, press the LOAD key
or the SAVE key. The display returns to the status
described in step 2.
⇒
To cancel the deletion, turn off the power switch. The
delete mode is terminated.
⇒
The welding condition of the selected JOB No. is
deleted, and "End" is displayed on the left/right
digital meters.
A
V
r
㧑
ARNING
m/min.
sec.
JOB No.
Hz
A
V
㧑
WARNING
m/min.
sec.
JOB No.
r
ENTER
㧔
3 sec.
㧕
Hz
A
V
r
㧑
WARNING
m/min.
sec.
JOB No.
Hz
