Daihen OTC Welbee P402L, Owner'S Manual

Page: 104 / 166

S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
102
T I P S
• When this function is set to [ON], automatically the setting of "4T/Crater repeat" is selected,
disabling other welding modes. (The 2T/4T menu does not work.)
• Single-clicking operation should be within 0.3 seconds.
• At the time of transition to crater, press the torch switch for at least 0.3 seconds.
• Welding process at crater treatment is the same as that of main welding.
Example:
In the setting examples of Initial welding current: 80 A; Main welding current: 100 A; and Crater current: 60 A, the
following diagram is available:
• In the following cases, this function cannot be used:
– Internal function F11 (Fine adjustment of welding JOB memory) is set to "1" to "30" (enabled);
– Internal function F44 (Reading welding JOB with remote control) is set to "ON" (enabled);
– Internal function F45 (Special 2T) is set to "ON" (enabled);
– Internal function F48 (Adjusting current with torch switch) is set to "ON" (enabled); or
– Either of the internal functions F29 to F32 (External input terminal setting) is set to either "4" (Start) or "5" (Loading
welding condition).
6.7.2.37 F52: Data type of data log function
This function enables to select data to save when using the data log function.
The patterns of data which can be saved are as shown in the below table.
For data log function; ( 7.3
-
Data Backup (Utilization of data)).
Setting
Welding current Welding current Welding voltage Welding voltage Wire feed speed Wire feed speed
(Command value) (Detected value) (Command value) (Detected value) (Command value) (Detected value)
0 - - - - - -
1 - Storable - Storable - Storable
2 Storable - Storable - Storable -
3 Storable Storable - Storable - -
4 Storable Storable - - - Storable
5 - Storable Storable Storable - -
6 - - Storable Storable - Storable
7 - Storable - - Storable Storable
8 - - - Storable Storable Storable
100 A
80 A
60 A
100 A
60 A
Press 0.3 sec. or more
100 A
60 A
Single
(within 0.3 sec.)
ON
OFF
Torch switch
Welding current
Crater-fil 㼘
Main welding Start condition
Crater-fil 㼘 Crater-fil 㼘
Main
welding
Main
welding