Dahua HCVR21**HS-S2 Series, User Manual

Page: 298 / 331

HDCVI Series DVR User
’s Manual
288
Parameter Function
mode HDCVI. The control signal is sent to the PTZ via the coaxial cable. For
the serial mode, the control signal is sent to the PTZ via the RS485
port.
Protocol
Please select corresponding protocol from the dropdown list.
Address
Set corresponding dome address. Default value is 1. Please note
your setup here shall comply with your dome address; otherwise
you can not control the speed dome.
Baud
Rate
Select the dome baud rate. Default setup is 9600.
Data Bit Default setup is 8. Please set according to the speed dome dial switch
setup.
Stop bit
Default setup is 1. Please set according to the speed dome dial switch
setup.
Parity Default setup is none. Please set according to the speed dome dial
switch setup.
5.8.5.5 ATM/POS
The ATM/POS function is for financial areas. It includes Sniffer, information analysis and title overlay
function. The Sniffer mode is network.
The network type interface is shown as below. See Figure 5-90.
Here we take the ATM/POS protocol to continue.
There are two types: with or without the protocol according to client
’s requirements.
With the protocol
For ATM/POS with the protocol, you just need to set the source IP, destination IP (sometimes you need
to input corresponding port number).
Figure 5-90
Without the protocol
For the ATM/POS without the protocol, the interface is shown as in Figure 5-91.