Dahua DH-HCVR5424L-S2, User Manual

Page: 292 / 340

HDCVI Standalone DVR User’s Manual
282
Parameter Function
Default setup is none.
5.8.5.5 PTZ
The PTZ interface is shown as in Figure 5-106.
Before setup, please check the following connections are right:

PTZ and decoder connection is right. Decoder address setup is right.

Decoder A (B) line connects with DVR A (B) line.
Click Save button after you complete setup, you can go back to the monitor interface to
control speed dome.
Figure 5-106
Please refer to the following sheet for detailed information.
Parameter Function
Channel
Select speed dome connected channel.
Control
mode
You can select control mode from the dropdown list. There are two
options: Serial/HDCVI. For HDCVI series product, please select
HDCVI. The control signal is sent to the PTZ via the coaxial cable. For
the serial mode, the control signal is sent to the PTZ via the RS485
port.
PTZ type There are two options: local/remote.
Protocol
Please select protocol as HD-CVI if you are using HDCVI mode.
Address
Set corresponding dome address. Default value is 1. Please note
your setup here shall comply with your dome address; otherwise
you can not control the speed dome.
Baud
Select the dome baud rate. Default setup is 9600.