Page 18
Specifications for Solar 130LC-V
Travel Deviation
To check steering deviation (travel motor balance), use a long tape or rope, or the edge of an undeviating
straight road curb or other marker to verify side-to-side travel motor uniformity.
Deviation distance s hould al ways be measured at t he 20 m (65' 7-1/ 2") “finish line.” Repeat the test in
reverse to measure in both directions, with starting point becoming the finish line, and vice versa. (Figure
6) A greater amount of deviation is allowed with the travel control set for high speed.
Swing Speed Test
Extend the bucket cylinder completely an d retract the arm cylinder, a s shown in Figure 8, to test swing
speed. The lowest point of the bucket will be approximately 1.0 m (3.3') off the ground.
Use paint marks at the s ame poi nt on t he turntable and undercarriage, or s elect alternate m easuring
locations and u se a stopwatch to time 3 full 360° rotations. The time required for 3 revolutions should be
between 14.0 and 16.0 seconds in Power Mode II, 13.0 and 15.0 seconds in Power Mode III.
RATE OF TRAVEL
MAX. DISTANCE
High Speed
150.0 mm (5.91 in.)
Low Speed
100.0 mm (3.94 in.)
Mode II
16.2 ±0.7 seconds
Mode III
15.0 ±0.7 seconds
0.3 ~ 0.5m
(1' - 1.5')
HJA7003L
Figure 7
1m (3.3')
HJA7005L
Figure 8
