Daewoo NUBIRA, User Manual

Page: 69 / 685

9P – 14 I DOORS
DAEWOO V–121 BL4
Up/Down or In/Out Adjustment
An adjustment of the striker in the up and down or in and
out directions may be necessary for a number of reasons:
vehicle frame damage as the result of a collision, installa-
tion of new door weatherstripping, customer complaints of
excessive windnoise, or difficulty in opening or closing the
door. In order to adjust the door striker in an up and down
or in and out direction, performthe following procedure:
1. The door must be properly aligned.
2. Loosen the striker screws.
3. The floating cage plate can be moved slightly using
the ends of the striker screws. Move the floating
cage plate to the desired position.
Notice : It is important to use a flat–end rotary file in order
not to damage the tapped floating cage plate. The striker
screws and the tapped floating cage plate are important
attaching parts that could affect the performance of vital
components and systems.
4. If proper adjustment requires that the floating cage
plate be moved more than is possible, use an elec-
tric hand drill and a 3/8–inch rotary file with a flat
head in order to enlarge the body opening in the
direction required.
5. Tighten the striker screws to the correct position.
Tighten
Tighten the door lock striker screws to 10 N
S
m (89 lb–
in).
FRONT DOOR LOCK
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the seal trim. Refer to”Door Seal Trim” in
this section.
3. Disconnect the inside door handle and the lock
rods.