
1. For Safe Operation
Damage that allows the microwave energy (that cooks or heats the food) to escape will result in
poor cooking and may cause serious bodily injury to the operator.
IF ANY OF THE FOLLOWING CONDITIONS EXIST. OPERATOR MUST NOT USE THE APPLI-
ANCE. (Only a trained service personnel should make repairs.)
1) A broken door hinge.
2) A broken door viewing screen.
3) A broken front panel, oven cavity.
4) A loosened door lock.
5) A broken door lock.
The door gasket plate and oven cavity surface should be kept clean.
No grease, soil or spatter should be allowed to build up on these surfaces or inside the oven.
DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITH THE DOOR OPEN. The microwave
oven has concealed switches to make sure the power is turned off when the door is opened. Do
not attempt to defeat them.
DO NOT ATTEMPT TO SERVICE THIS APPLIANCE UNTIL YOU HAVE READ THIS SERVICE
MANUAL.
2. For Safe Service Procedures.
1) If the oven is operative prior to servicing, a microwave emission check should be performed prior
to servicing the oven.
2) If any certified oven unit is found to servicing, a microwave emission check should be performed
prior to servicing the oven.
(a) inform the manufacturer, importer or assembler,
(b) repair the unit at no cost to the owner,
(c) attempt to ascertain the cause of the excessive leakage,
(d) tell the owner of the unit not to use the unit until the oven has been brought into compliance.
3) If the oven operates with the door open, the service person should tell the user not to operate
the oven and contact the manufacturer and CDRH immediately.
2
CAUTION : This device is to be serviced only by properly qualified service personnel. consult the
service manual for proper Service procedures to assure continued safety operation
and for precautions to be taken to avoid possible exposure to excessive microwave
energy.
PROPER USE SERVICE PRECAUTIONS
CAUTIOU
MICROWAVE RADIATION
PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY
RADIATE FROM THE MAGNETRON OR OTHER MICROWAVE GENERATING DEVICE IF IT
IS IMPROPERLY USED OR CONNECTED. ALL INPUT AND OUTPUT MICROWAVE CON-
NECTIONS. WAVEGUIDE, FLANGES AND GASKETS MUST BE SECURE. NEVER OPERATE
THE DEVICE WITHOUT A MCROWAVE ENERGY ABSORBING LOAD ATTACHED. NEVER
LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGIZED.
Summary of Contents for KOG-361Q
