Daewoo KOG-361Q, Service Manual, Page: 24 / 58

(1) Remove the gasket door (A06) from door plate (A04).
(2) Remove the barrier screen inner (A05) from door plate (A04).
(3) Remove the door frame (A02) from door plate (A04).
(4) Remove the top hinge stopper (A03) from door plate (A04).
(5) Remove the spring (A08) and the hook (A07).
(6) Remove the barrier screem outer (A01) from door frame (A02).
(7) Remove the above steps for reassenbly.
4. Method to reduce the gap between the
door seal and the oven front surface.
(1) To reduce gap located on part ‘A’
1) Loosen two screws on the top hinge
stopper, and then push the door to con
tact the door seal to oven front sur-
face.
3) Tighten two screws.
(2) To reduce gap located on part ‘B’.
1) Loosen three screws in under hinge stopper, and then the door to contact the door seal to
oven front surface.
2) Tighten three screws.
(3) To reduce gap located on part ‘C’. (See Fig. A)
1) Loosen a screw on the interlock switch assembly located at the bottom of the oven body.
2) Draw the interlock switch assembly inward as possible with hook on the door bottom.
3) Tighten a screw.
(4) To reduce gap located on part ‘D’. (See Fig. B)
1) Loosen a screw on the interlock switch assembly located at the top of the oven body.
2) Follow step (3) 2) and 3).
23
NOTE:
A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.