Safety Section
-11-
Inspect the part of the chain that is normally operated
over the crosshead roller. When the chain bends over
the roller, the movement of the parts against each other
causes wears.
Inspect to be sure that chain link pins do not extend
outside of the bore hole.
If any single link pin is extended beyond its connecting
corresponding link, it should be suspected of being
broken inside of its bore hole.
Inspect the chain anchor and the anchor links for wear.
Do not change any factory set adjustment
values(including engine rpm setting) unless you have
both authorization and training. Especially Safety
equipment and switches may not be removed or
adjusted incorrectly. Repairs, adjustments and
maintenances that are not correct can make a
dangerous operating condition.
For any checkup, repair, adjustments, maintenance and
all other work concerning your forklift truck, please
contact your
DOOSAN
dealer. We would like to draw
your attention to the fact that any secondary damages
due to improper handling, insufficient maintenance,
wrong repairs or the use of other than original
DOOSAN
spare parts waive any liability by
DOOSAN
.
Operation Information
Mounting and Dismounting
Mount and dismount the lift truck carefully.
Clean your shoes and wipe your hands before mounting.
Face the lift truck when mounting and dismounting.
Use both hands face the lift truck when mounting and
dismounting.
Use the handgrips for mounting and dismounting.
Do not try to climb on or off the lift truck when carrying
tools or supplies.
Never get on or off a moving lift truck.
Do not use any controls as handholds when entering or
leaving the operator's station.
Never get on or off a moving lift truck. Never jump off the
lift truck.
Keep hands and steering wheel free of slippery material.
Before Starting the Lift Truck
Perform a walk-around inspection daily and at the start
of each shift. Refer to the topic “Walk-around Inspection”
in “Every 10 Service Hours or Daily” section of this
manual.
Adjust the seat so that full brake pedal travel can be
obtained with the operator's back against the seat back.
Make sure the lift truck is equipped with a lighting
system as required by conditions.
Make sure all hydraulic controls are in the HOLD
position.
Make sure the direction control lever is in the NEUTRAL
position.
Make sure the parking brake is engaged.
Summary of Contents for D35S-2
