Connection Diagram
1. Connect camera and TDM08-SDI-TX’s VIDEO IN using coax cable.
- If non PoC Camera: Supply the individual power to camera. To control the camera’s PTZ
and/or OSD, connect the RS485 line between camera and TDM08-SDI-TX.
- If PoC Camera: Don’t require any other cables except COAX cable.
(non PoC DVR can use PoC camera because TDM08-SDI-TX is PoC
device.)
2. Connect TDM08-SDI-TX and OPT Receiver using Optic cable (Single
mode, LC Type).
- When you connect the Optic cable to TDM08, connect pushing
enough until you hear the “click” sound.
- Pull the lever on the arrow shown in Figure 1) to tightly lock the cables into connector.
- Please use OPT-RX1-RS485U for non PoC DVR and OPT-RX1-RS485P for PoC DVR.
3. Connect OPT Receiver’s COAX output and DVR’s video input using COAX cable.
- Usable TDM channels are determined according to DVR models. Please refer the DVR’s
manual for DVR’s TDM configuration and usage.
- Please connect RS485 lines between non PoC DVR and OPT receiver (OPT-RX1-RS485U)
to control camera (PTZ and/or OSD).
- If PoC DVR: Only coax cable is required to control camera (PTZ and/or OSD).
4. Set the CoC OUT switch as OPT.
5. Check the OPT LINK LED is ON.
