![background image](http://html1.mh-extra.com/html/daelim/s3/s3_service-manual_3057410016.webp)
9. Check to see if the rubber part is worn out when
removing it and replace it if necessary. Some rubber part
is weak to gasoline and kerosene, so pay attention not to
soak with gasoline or oils.
10. Recommended grease must be applied to or filled in
the specified place.
7. Align the bolts to uniform the tightening points before
tightening them when you don’t know the bolt length.
8. Bolts, nuts and pieces must be tightened from the bigger
diameter to the smaller one, from inside to outside and
diagonally with the specified torque.
5. Clean the parts after the overhaul and before the test and
remove the cleaning oil with compressed air. Apply oil
to seal face during installation.
6. Check necessary place and measure necessary data dur-
ing installation. When installing, return to the state
before removing.
11. Maintenance needed to use the specialized tools must
performed with the right tool.
12. Never reuse the ball bearing removed with the ball
applied pressure when removing press-fitted the bear-
ing.
SERVICE INFORMATION
Summary of Contents for S3
Page 1: ...SM63 1010 01E...