DAELIM BESDI 125 - SERVICE, Service Manual

Page: 154 / 193

14-8
BRAKE SYSTEM
Install the primary cup with its concaved side toward
the inner side of the master cylinder.
Install the snap ring.
TOOL : SNAP RING PLIERS
CAUTION
When installing the cups, do not allow the lips to turn
inside out.
Note the installation direction of the snap ring.
Be certain that the snap ring is seated firmly in the
groove.
Install the rubber boot in the groove properly.
INSTALLATION
Install the front / rear master cylinder to the handle bar.
NOTE
Install the holder with its “UP” mark facing upwards,
and align the holder joint with the punch mark on the
handle bar.
Tighten the holder upper bolt first.
Install the brake hose to the master cylinder with 2 new
sealing washers and the hose bolt.
TORQUE VALUE : 2.5~3.5 kgf m
Loosen the 2 flat screws, remove the oil cup cap,
diaphragm plate and diaphragm.
Fill the brake fluid, and bleed air.
Install the diaphragm, diaphragm plate and the oil cup
cap, tighten the 2 flat screws.