2
4
English
I
nstallation
Instruction
s
Hanging the Hood, cont.
Hanging
slots
Mounting
hole
s
5. (If needed) Mark the top of the hood if the
configuration calls for the hood to be secured at
the top.
6. Remove the hood from the wall.
7. Drill the pilot or anchor holes. (If using anchors,
insert them into the anchor holes.)
8. Reset the hood on the holding brackets.
9. Adjust as needed, then anchor the hood.
Hardwiring the Hood
Power may be suppled to the hood through an electrical junction box or a dedicated 15-Amp. circuit
breaker.
WARNING
•
Before connecting the wiring, turn OFF power to the hood at the fuse box or circuit breaker.
•
Miswiring the hood creates an electric shock or fire hazard and may harm its electrical system.
•
Do not ground the wires to the neutral (white) wire. Connect the ground wire to a separate,
properly grounded wire installed by a licensed electrician.
•
Use proper-gauge wiring that meets all codes and can accommodate the total connected loads.
Top Access
Rear Access
1. Shut power OFF at the circuit breaker or fuse box.
2. Feed the cable assembly through the hood.