English
2
3
Installation
Instruction
s
Using the Optional Dual-to-Single Transition Kit #AHT10
, cont.
Installing the AHT10 Transition Kit (top-/rear-vent configuration)
NOTE
The transition kit does not include the sheet-metal screws needed to install the hood.
Top-Vent
Rear-Vent
1.
Center the transition kit over the duct collars.
2.
Drill screwholes in the flanges, being sure to pierce the hood top.
3.
With sheet-metal screws, fasten the AHT10 unit to the hood.
4.
With foil tape/duct tape, seal the AHT10 unit’s base.
Hanging the Hood
WARNING
Hanging the range hood requires two people. Do not lift the hood unassisted.
IMPORTANT:
Take care not to scratch/damage the hood. Hanging slots in the hood back engage
the holding brackets to support the hood temporarily during installation.
1. Remove the plastic film from the hood.
2. Lift, and slip the hood onto the holding brackets
through the hanging slots in the hood back.
3. Adjust the hood into its final position.
4. Mark the spot by drawing in a mounting hole in
the back of the hood. (This is where a screw will
hold the hood to the wall stud or concrete
anchor.)
Bracket
attached to
wall
Bracket
slot (on
hood
back)
Adjacent
cabinetry
Adjacent
cabinetry
