Dabi Atlante Spectro 70X Series, Owner'S Manual

Page: 34 / 44

34
Radiography test
After the assembly of the equipment the authorized technician
must carry out a radiography test, using the materials (film, dark
room, processor and fixator) supplied by the client, following the
instructions below:
Place the head directed downwards (90o position) next to an
horizontal surface (aprox. 50 mm).
Centralize the film (25) utilizing for such the auxilliary points (24)
existing on the Collimator Cylinder (23), put over the film (25), a
metallic object (26). (Ex.: clips or coin) as in the figure below:
Select a time scale of 0.32 seconds.
Activate the button “Start” (06) (see pg. 30).
Radiography carried out with:
• Kodak Film. - It is not provided
with the product
• Ektaspeed Type
Caution:
Never test the device with the cylinder aimed to you, or people that are next to the place Always
do the test with the cylinder aimed downwards, by keeping a minimum distance of 2m.
NOTE:
The material (clips, coins, film, etc) will not be contaminated, and
can be taken out after trigger.
Develop the film at Dark Room with the following times:
- 1 minute at development;
- 1 minute at fixation.
Afterwards, check if radiography is according to indicated
standard.
In case of differences in comparison, see page 40 “fault”.
If it is not possible to test by the authorized technician (because
of lack of material) the proprietary will be responsible for it before
initiating operations.
24
25
26
23
OPERATION OF EQUIPMENT