Dabi Atlante Spectro 70X Series, Owner'S Manual

Page: 30 / 44

30
Operating Instructions of Transmitter Assembly How to move the cylinder head
OPERATION OF EQUIPMENT
Operating Instructions
- When moving the cylinder head, grasp the cylinder (02) and back part (01) as shown in the picture.
Only after an authorized technician have properly installed and
tested the equipment, it will be ready to work.
Verify if the equipment is connected to the main grid.
Turn on the general switch (09) and a green light will turn on.
Choose the time scale from 0 to 3.2 seconds according to the work
to be performed. “See radiographic technique chart on page 33”
and set it through the buttons (04 and 05) located on the control.
When the patient is properly prepared for the radiography:
Remove the support control, press the shutter-button (06) (Beep
beeping) and keep it pressed.
The “yellow” LED must be lighted during radiation emission.
Note: Turn off the general key (09) whenever the equipment is
not in use.
Always keep the remote control in its holder.
Note: If the messages appear on the display:
•A1 •A2
•A3 •A4
•Sb •A5
NOTE:
The value indicated on the digital command display refers to the exposure time. To obtain the charge
application time, add 0.2 seconds (pre-warming) to any value indicated on the display.
- As it is a pulse device and depends on the wiring frequency, it is not possible to provide time of
0,063s belonging to geometric series within the range of ± 10%.
( IEC 60601-2-7 : 29.1.106 E)
See page 40 “Unforeseen situations”
01
02
04
07
09
08
06
03
05