MANU0140 Rev. 0 2/2019
9
Before each treatment, the Link Controller will ask you about the condition of your skin since your prior
treatment. It will use this information to calculate your next dose. It is normal to experience some slight
“pinkness” about 8 – 12 hours after a treatment, which is typically gone before it is time for your next treatment.
Operating the Home Link
TM
Control System
Setting up a Treatment
1. Touch the screen to awaken the unit and open the Logo screen. Touch the Logo screen. The Lock
screen will appear (if enabled).
2. Enter in your Key Code using onscreen keypad. Unless you have changed it, the factory preset Key
Code will be 0007.
3. Once the key code is entered, the Treatment screen will appear. The first time you use the device, your
first dose will automatically appear, based on your doctor’s prescription. After your first treatment, this
screen will display the next scheduled treatment, but will also ask if you experienced any pain or redness
after your last treatment. Based on your response, the Link Controller will adjust your treatment
according to your prescription.
•
Were you in pain or red after your last treatment?
No, or less than 24 hours ( “Not at all, or it was gone in less than 24 hours” )
24 – 48 hours ( “I was in pain or red for 24-48 hours after the treatment” )
More than 48 hours ( “I was in pain or red for more than 48 hours” )
Still red / pain ( “I am currently still red or have pain” )
Note:
Selection of the “Still red / pain” option will instruct the user to skip a treatment, and will
lock the device until one treatment has been skipped as an intentional safety measure to prevent
treating the skin until the erythema (redness) has resolved.
4. Once you have highlighted your response, tap the Enter key.
5. The Treatment Confirmation screen will appear and will display the dose and an estimated time for your
treatment. If changes need to be made, press the back arrow.
To cancel press X.
6.
Put on your goggles and position yourself 9 inches from the front of the device.
7. Tap the Enter key
to begin the treatment. A 3 second countdown will begin, and then the lamps will
turn on.
8. The screen will display your progress and the lamps will shut off when the treatment is over. If you need
to pause in the middle of the treatment, tap the Pause button.
Tap the Play button to resume.
9. You have now treated one half of your body. To treat your entire body, you will need to repeat the same
dose on the other half. To repeat the same dose, touch the Repeat button.
.
Special Notes
•
If power goes off during a treatment, the system will remember how much of the treatment has elapsed.
When power is restored, your device provides an option to resume interrupted treatment.
