4
Method 1 for Screens with a Viewing Width of 80" and Smaller
1. Use the supplied #10 screws to attach three frame brackets to
the back of the frame as shown in Figure 2.
2. Secure the large wall bracket to wall studs at the desired height.
Make sure the bracket is level. The top of the frame will be 1/8"
above the top of the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the screen.
3. To install the small wall bracket, you must measure the overall
height of the screen frame and subtract 1-3/8". Using that
dimension, measure down from the top edge of the large wall
bracket and mark the wall for two screw holes. The holes should
be centered within the frame and 6" apart. Refer to Figure 3.
Frame Brackets
3-Pieces
#10 Screws
6-Pieces
Large Wall
Bracket
1-Piece
Small Wall Bracket
1-Piece
Figure 2
4. Attach the small wall bracket to the wall. Refer to Figure 4
for proper orientation. Do not tighten the screws completely. The
bracket should slide up and down easily.
NOTE:
Use provided gloves for steps 5 and 6.
5. Attach surface to screen using instructions on page 6.
6. After the surface is attached, hang the screen on the brackets by
hooking the bottom of the frame onto the small wall bracket and
lift up until you can hook the top of the frame on the top bracket.
Gently push down on the frame to seat it on the brackets. Refer
to Figure 4.
NOTE:
Pushing down too hard on the frame to seat brackets
may cause damage to the screen surface.
2
Lift
3
1
W
all
Figure 4
6"
Figure 3
Overall
Height
Overall Height - 1 3/8"
