DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
149
JWAC Port Settings
To configure JWAC port settings for the Switch, go to the
Security
folder, open
JWAC
, and click
JWAC Port Settings
, which
will open the following window:
Figure 9- 36. JWAC Port Settings window
To set the JWAC on individual ports for the Switch, complete the following fields:
Parameter Description
From Port
Use this drop-down menu to select the beginning port of a range of ports to be enabled as
JWAC ports.
To Port
Use this drop-down menu to select the ending port of a range of ports to be enabled as
JWAC ports.
Aging Time (1-1440)
This parameter specifies the time period during which an authenticated host will remain in the
authenticated state. Enter a value between
0
and
1440
minutes. A value of
0
indicates the
authenticated host will never age out on the port.
MAC Authenticating
Host (1-10)
This parameter specifies the maximum number of host process authentication attempts
allowed on each port at the same time. Enter a value between
1
and
10
attempts.
Idle Time (1-1440)
If there is no traffic during the Idle Time parameter, the host will be moved back to the
unauthenticated state. Enter a value between
0
and
1440
minutes. A value of
0
indicates the
Idle state of the authenticated host on the port will never be checked.
Block Time (0-300)
This parameter is the period of time a host will be blocked if it fails to pass authentication.
Enter a value between
0
and
300
seconds.
State
Use this drop-down menu to enable the configured ports as JWAC ports.
Click
Apply
to implement changes made.