D-Link DWS-3024L, User Manual, Page: 55 / 268

Connecting the Switch to the Network 55
4 Installing the D-Link Unified Access System
Connecting the Switch to the Network
After you perform the physical hardware installation, you need to connect the D-Link Unified
Switch to the network. The default IP address of the switch is 10.90.90.90/8, and DHCP is
disabled by default. If you want to enable DHCP on the switch or assign a different static IP
address, you must connect to the switch and change the default settings.
You can connect to the switch through Telnet or a Web browser from a host on the 10.0.0.0/8
network, or you can connect to the switch through the console port (RS-232 DCE). After you
connect to the switch, you can provide network information or enable the DHCP client.
To connect to the switch from a host on the 10.0.0.0 network, enter the default IP address of
the switch (10.90.90.90) into the address field of a Web browser or a Telnet client.
To connect to the console port and provide network information, use the following steps:
1. Using a null-modem cable, connect a VT100/ANSI terminal or a workstation to the
console (serial) port.
If you attached a PC, Apple, or UNIX workstation, start a terminal-emulation program,
such as HyperTerminal or TeraTerm.
2. Configure the terminal-emulation program to use the following settings:
- Baud rate: 115,000 bps
- Data bits: 8
- Parity: none
- Stop bit: 1
- Flow control: none
3. Press the return key, and the
User:
prompt appears.
Enter
admin
as the user name. There is no default password. Press ENTER at the password
prompt if you did not change the default password.
After a successful login, the screen shows the
(switch-prompt)>
prompt.
4. At the (
switch-prompt) >
prompt, enter
enable
to enter the Privileged EXEC command
mode. There is no default password to enter Privileged EXEC mode. Press ENTER at the
password prompt if you did not change the default password.
The command prompt changes to (
switch-prompt)#
.
5. Configure the network information.
- To use a DHCP server to obtain the IP address, subnet mask, and default gateway
information, enter
network protocol dhcp
.
- To use a BootP server to obtain the IP address, subnet mask, and default gateway
information, enter
network protocol bootp
.
- To manually configure the IP address, subnet mask, and default gateway, enter
network parms <ipaddress> <netmask> [<gateway>
], for example:
network parms 192.168.2.23 255.255.255.0 192.168.2.1
The default gateway is an optional parameter, so you do not need to enter an address
to execute the command.