3.2 Configuring WLAN Settings
All of the features you configure in this section are within the
WLAN
tab on the D-LINK
Wireless Switch.
3.2.1 Configure the Basic Settings
Use the following steps to configure the Wireless Switch and the APs.
1. On
the
Global
tab of the
Administration
Æ
Basic Setup
page, make sure the
switch IP address is the Loopback interface address (192.168.10.254), the country
code is correct, and that the
WLAN Switch Operational Status
is Enabled.
2.
Click
Next
to go to the Discovery tab on the Basic Setup page.
3.
Add the IP address for AP2 (172.17.6.1, which is on the “customer” network) to the
L3/IP Discovery
list, and then click
Submit
(Note: since you do not know for sure which
IP address the DHCP Server on the “customer” network will provide to AP2, you can
configure a range of IP addresses to add to the L3 Discovery list).
4.
Click the
SSID
tab to configure the VAP and Network settings for the L3-Tunnel
network..
5.
Select the 802.11b/g radio.
6.
Select the check box next to Managed SSID 4 and click
Edit
.
7. Change the following Network parameters and select
Submit
:
b.
SSID
– L3-Tunnel
c.
L3 Tunnel Check Box
: Enabled
d.
L3 Tunnel Subnet
: 192.168.250.0
e.
L3 Tunnel Mask
: 255.255.255.0