DGS-8000 Series Hardware Installation Guide Chapter 1 Product Overview
21
Note
1. The first 12 ports of the 8000-24SC-E module are fiber/copper combo
ports. That is, each SFP port corresponds to a combo
10/100/1000BASE-T port, and only one port can be used at a time, with
the other being unavailable. The automatic MDI/MDI-X identification of
10/100/1000BASE-T copper ports is effective only when auto-negotiation
is enabled.
2. The 8000-24SC-E module supports 1000BASE-X and 100BASE-FX.
You should configure the ports as desired operating modes according to
the Configuration Guide
1.4.4
8000-48TC-E Module
1.4.4.1
Introduction
Figure 1-12 shows the appearance of the 8000-48TC-E module. This module provides 44
RJ-45 ports for 10/100/1000BASE-T and four fiber/copper combo ports. SFP ports support
100/1000M rate, and RJ-45 ports support 10/100/1000M autonegotiation. SFP optical
modules support hot swap.
Figure 1-12 8000-48TC-E appearance
1.4.4.2
LEDs on the Module Panel
The 8000-48TC-E module provides LEDs indicating system states. The Status LED
indicates the operating status of a board itself, and each port provides a Link/ACT LED to
indicate the operating status of the port itself. Table 1-9 shows their detailed meanings.
Table 1-9 LEDs on the front panel
LED
Identifier
Status
Meaning
Off
The module is not powered on.
Solid Red
The module is abnormal.
System LED Status
Blinking green
The module is being initialized. If the
LED blinks all the time, it indicates
that the module is abnormal.
Operating
humidity
10% to 90% RH
Weight
3.2kg (net)
Dimensions (L x
W x H)
436 x 346 x 45 mm
Summary of Contents for dgs-8000 SERIES
Page 1: ...DGS 8000 Hardware Installation Guide ...
Page 97: ......