12
Troubleshooting the Hardware Installation
If you experience any problems with the hardware installation, first
ascertain that all network cable connections are firm, that the proper
grade of cable is used for the network connection, and that the cable
makeup is correct (straight –– without un-needed crossovers in the
connector wiring). Check that the supporting hub is powered-on and
operating normally, and that the hub is properly qualified (under 10Base-
T and/or 100Base-TX standards).
Verify Each Computers Identification
If more than one computer on your network has the same “Computer
name,” communications may be negatively affected. Also, each
computer must have the same “Workgroup” name to communicate
properly.
Verify Network Adapter Installation
If your Network Adapter were not installed, including the Network
System Software or Device drivers, your network will not function
properly. Use these steps to verify that your Network Adapter is properly
installed.
1. Double-Click the “System” icon in the Control Panel.
2. Click the “Device Manager” tab on top of the “System
Summary of Contents for DFE-690TXD
