D-Link DES-3528 - xStack Switch - Stackable, User Manual, Page: 241 / 322

xStack
®
DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
240
Precedence
header.
Rx Rate (1-15624)
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented
using the following equation: 1 value = 64Kbit/sec. (ex. If the user selects an Rx rate of
10
then the ingress rate is 640Kbit/sec.) The user many select a value between 1 and 15624 or
tick the No Limit check box. The default setting is No Limit.
Time Range Name
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the
Time R ange Settings
window. This will set specific times when this
access rule will be implemented on the Switch.
Counter
Enable or disable the counter settings.
Ports / VLAN Name /
VLAN ID
Use the pull down menu to select Ports , VLAN Name , or VLAN ID that the access rule will
take effect on, and enter a range of ports to be configured, or the VLAN name/ID of a
previously configured VLAN.
Click
Apply
to display the following
Access Rule List
window.
Figure 7 - 20 Access Rule List (IPv6)
To view the configurations for previously configured rule click on the corresponding
Show Details
Button which will
display the following
Access Rule Details
window.
Figure 7 - 21 Access Rule Detail Inforamtion (IPv6)
To configure the
Packet Content ACL
select Packet Content in the Add ACL Profile window, enter the Profile ID and
Profile Name into the top half of the screen in the
Add ACL Profile
window and click
Select,
the following window will
appear.