D-Link DES-3326SR, User Manual

Page: 166 / 359

DES-3326SR Layer 3 Fast Ethernet Switch User’s Guide
154
The IP address may alternatively be set using the
Command Line Interface (CLI) over the console serial port
as follows
:
1. Starting at the command line prompt DES3326SR4#
−
enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy . Where the x ’s
represent the IP address to be assigned to the IP
interface named
System and the y ’s represent the
corresponding subnet mask.
2. Alternatively, you can enter DES3326SR4#
−
enter the
commands config ipif System ipaddress
xxx.xxx.xxx.xxx/z . Where the x ’s represent the IP
address to be assigned to the IP interface named
System and the z represents the corresponding number
of subnets in CIDR notation.
Using this method, the switch can be assigned an IP address
and subnet mask which can then be used to connect a
management station to the switch’s web-based management
agent.
Saving Configuration Changes
Clicking the Apply button makes any configuration change
active, but only for the current session. If the switch is
restarted (rebooted) without entering the configuration changes
into the non-volatile RAM (NV-RAM), the configuration changes
will be lost.
To enter configuration changes into the switch’s non-volatile
RAM, select
Save Changes from the main screen. Click on the
Save Configuration button to enter the current configuration
into NV-RAM. The configuration will then be loaded into the
switch’s memory when it is restarted.