4
Assembly of the cutter (5)
Install the working table by
tightening 3 long screws. And
also use included screws to
install the handles on each side
of the cutter base.
Warning:
Do not put your
fingers against the sharp edge
of the blade at any time.
Assembly of the cutter (6)
Swing the supporting roller to
form a 90 degree with the 2
guide bars and use included 2
screws to tighten the parts as
shown.
Insert the extension supporting
roller under the working surface as
shown. Please note 2 screws must
be put onto the end of the guide
bar as shown as the stoppers.
Warning:
Do not put your
fingers against the sharp edge of
the blade at any time.
Assembly of the cutter (4)
Use provided spacer and nut to
tighten the cutting head and
supporting plate in position. But
do not over tighten it.
Warning:
Do not put your
fingers against the sharp edge of
the blade at any time.
