9
Now we should unlock the angle in the third enclosure to place it on the second (in this configuration the
rear trigger is hidden, as seen on page 7).
To do this we will move the handles on the sides of the enclosure up to the end where you will hear a
click.
At that time the rear trigger will come out, the moved handle will be locked and it will unlock the angle.
Taking the third enclosure by the handles, we will lower it gently upon the second enclosure, until it rests
upon it.
Remove the safety pins on each side of the box and to anchor the enclosure we will use these pins as
shown in the figures, on page 7.
Once the third enclosure is supported by the second and the front safety pins are positioned, we will
choose also 7º with the angle selector and we will put the rear safety pins on the second enclosure (two on
each side of the enclosures): put pins in REAR LINK holes of third enclosure and others, in the holes
corresponding to 7º angle, on the second enclosure (as shown in the figures below and as seen on page 8).
Check that all safety pins are located correctly because they will have to withstand the weight of all the
enclosures.
These figures show final mounting of three
enclosures on a
PL-20S
platform. We can leave
the front rods prepared for stacking the fourth
enclosure, only if the group isn't finished.
Manual de Colgado
/ aero series /
Rigging Manual