17
1.
2.
3.
Now, we shall proceed to assign the angles in the next
group of 4 units, as before, with the same procedure we shall
assign:
Between fourth and fifth: 2º
Between the fifth and sixth: 4º
Between the sixth and seventh: 6º
Between the seventh and eighth: 7º
As we have done before and according to the following
figures.
1.- First, we will draw the
rods from the upper unit (box
No.5) of the new group of boxes
(as on page 11). Then we shall
assign the angle between the
upper enclosure of the next
group and the lower enclosure
of the previous group. For this,
we will insert the security pins in
the SELECT ANGLE holes
corresponding to 2º.
2.- We shall let down
the previous group until
the front rods of the
upper box of the new
group (box No.5) are
aligned with the holes of
the lower enclosure of
the previous group (box
No.4). Then we shall put
the security pins to link
the front.
3.- We shall continue
lowering the upper group
until fully supported by the
lower group. Finally, we
will put the security pins in
REAR LINK holes of box
No.4, joining all boxes.
DETAILS
Box No.1
Box No.5
Box No.2
Box No.6
Box No.3
Box No.7
Box No.4
Box No.8
Manual de Colgado
/ aero series /
Rigging Manual
