Getting Started With EZ-
BLE™ PRoC™ Module
www.cypress.com
Document No.: 001-96841 Rev. **
16
The CYBLE-022001-EVAL board contains the following components:
Cypress EZ-BLE PRoC Module (CYBLE-022001-00)
– soldered directly to the Evaluation Board
PCB substrate used for I/O fan out
Connection headers
C
mod
capacitor (for use with Capacitive Sensing elements on the CY8CKIT-042-BLE kit)
Inductors (power supply
– see the
datasheet specification
for recommended external components)
This evaluation board is designed to simulate the placement and connection of the EZ-BLE PRoC Module in a final
application. All host-side layout pattern recommendations (as shown in
Figure 5
) are followed in the evaluation board.
Note that not all connections available on the CY8CKIT-042-BLE are populated on the CYBLE-022001-00/CYBLE-022001-
EVAL modules. This is due to the number of I/Os supported on the CYBLE-022001-00 module. When designing applications,
PSoC Creator will only display connections that are available on the CYBLE-022001-00 module and CYBLE-022001-EVAL.
The next page will describe in detail the connections of the CYBLE-022001-EVAL board and the corresponding connections
on the CY8CKIT-042-BLE development kit.
To place the CYBLE-022001-EVAL on the CY8CKIT-042-BLE baseboard, locate the 20-pin (J11) and 24-pin (J10) connection
headers, as shown in
Figure 16
.
Figure 16. CY8CKIT-042-BLE Baseboard with J10 and J11 Headers to Connect the CYBLE-022001-EVAL
Plug the CYBLE-022001-EVAL module into the CY8CKIT-042-BLE baseboard on headers J10 and J11, while keeping the
antenna directed outside.
To remove the CYBLE-022001-EVAL evaluation board from the CY8CKIT-042-BLE baseboard, hold the CY8CKIT-042-BLE
baseboard in one hand and the CYBLE-022001-EVAL in the other, as shown in
Figure 17
, and pull it out using a rocking
motion.
Figure 17. Removing the CYBLE-022001-EVAL from the CY8CKIT-042-BLE Baseboard
