Example Projects
CY8CKIT-044 PSoC® 4 M-Series Pioneer Kit Guide, Doc. No. 001-96598 Rev. *C
29
4.5.2 Hardware Connections
Connect five-inch wires (provided with this kit) to proximity headers J10 and J11 on the PSoC 4 M-Series Pioneer Kit, as
shown in
Figure 4-9
.
Figure 4-9. Proximity Sensor Connection on PSoC 4 M-Series Pioneer Kit
4.5.3 Verify Output
To verify the Proximity Gestures example project, follow these steps:
1. Power the PSoC 4 M-Series Pioneer Kit through USB connector J6.
2. Program the PSoC 4 M-Series Pioneer Kit with the
CY8CKIT_044_Proximity_Gestures
example project.
3. Connect the proximity sensor wires as shown in
Figure 4-9
, and press the reset switch of the kit (SW1). You should
bend the wire to form a loop, as shown in
Figure 4-9
to get better proximity range.
4. Bring your hand close to the proximity sensors. The RGB LED will turn ON with white color.
5. The brightness of the LED will increase as you bring your hand closer to the proximity sensors.
6. Wave the hand at a close proximity from the bottom sensor to the top sensor (UP gesture) to see the LED color change
in the order Red > Green > Blue > Red, one color at a time with each wave.
7. Wave the hand at a close proximity from the top sensor to the bottom sensor (DOWN gesture) to see the LED color
change in the order Red > Blue >Green > Red, one color at a time with each wave.
Power consumed by PSoC 4200M for this project can be measured using an ammeter as described in the
Deep-Sleep
Blinky
project.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
