Reporting
44
© 2021 Cypress Solutions
Complete Manual: CTM-200 R2 (Revision 1.4)
Irregular and Infrequent reports are triggered by the below conditions, the GPS condition will typically
trigger a regular AVL type report.
Triggers or events
Description
Event
Label
GPS
8 available conditions can be triggered on time, speed (low
speed, high speed), distance travelled, heading change.
GPSx
Input Condition
8 available conditions, time based, alarm based on input
states of 6 inputs, up to 2 inputs can be compared in each
condition. IP change trigger
GPIOx
Ignition
8 available conditions, triggers on ignition going off, on or
transition.
IGNx
OBDII or J1939
8 available conditions. Time based, or based on a valid OBDII
or J1939 parameter being =,>,< the reported value from the
vehicle ECU
OBDx
Power Up
8 available conditions, triggers on the device being powered
up.
PUPx
Voltage
8 available conditions, trigger when a supply voltage is
below, above or a supply threshold is passed.
VCCx
Acceleration
8 available conditions, triggers when an acceleration,
deceleration or lateral acceleration threshold has been met.
ACCELx
Geo Route
In Zone or Out of Zone trigger, or alarm triggers based on
crossing of zone threshold.
GEOx
Idle
Trigger a report when an idle time is exceeded
IDLExSTART
IDLExEND
Data
Triggers when a pre-configured threshold is exceeded.
DATAx
MODBUS
Trigger MODBUS or MODBUS exception reports
Man Down
Triggers when Man-Down Accessory device generates an
event (CTM-200 must be configured to listen for traffic and
optional WPAN Gateway must be installed)
MANDOWNx
Boomtracker
Triggers when short range wireless asset tracker accessory
comes within range of CTM-200 (CTM-200 must be
configured to listen for traffic and optional WPAN Gateway
must be installed).
BOOMx
Proximity Card/RFID/I-
Button
Triggers when a compatible RFID device sends a message to
the CTM-200 via external peripheral, RFID reader, etc. (uses
modified message 114, $PGPS for payload)
RFIDx
External Equipment
Triggers when supported external equipment sends data to
CTM-200 serial port. Typical External equipment include salt
spreader, weigh systems, etc. (uses modified message 114,
$PGPS for payload)
EXTz
11.5
Report Definition
A report definition consists of:
•
Transport protocol (UDP, TCP, SMS, email, asynchronous, file based)
•
Destination IP address
