Device Management
38
© 2021 Cypress Solutions
Complete Manual: CTM-200 R2 (Revision 1.4)
the response to be sent back to the sender. Both commands can act as a remote management and
configuration tool for CTM-200 gateways.
Any of the CTM-200 commands can be appended after $0/$1 except for the following commands, which are
discarded by the SMS command processor:
cmd event dump
cmd showconfig
cmd factory
No configuration of the CTM-200 is required for it to accept SMS commands
Message format:
$1<ctm command> if the command provides feedback.
$0<ctm command> if the command does not provide feedback.
The first two characters of the message should always be
$0 or $1
. Any of the CTM-200 commands can be
appended after
$0 or $1
except for the commands discarded by the SMS command processor (See list
above.). Moreover, multiple commands separated by
<CR>
or
<CR><LF>
can be sent in a single SMS
message\
Examples:
1.
Return firmware version to SMS sender
$1cmd ver
Returns: 5555551212:r2.0.5.2779-144
2.
Issue command to power cycle only
$0cmd pwr mode 2
Note: commands that output more than 160 characters will not generate feedback.
sendsms –P<PHONE #> -T<$0 or $1 ctm command> sends ctm command to another CTM-200
