CYP CPHD-V4L, Operation Manual, Page: 29 / 76

24
1) Timing: Select the output resolution and refresh rate.
2) Pattern: Select the test pattern to display.
3) Format: Select the video format for the output.
Note: DVI mode does not support audio output or the YUV color space.
4) Colorspace: Select the color space format for the video output.
Note: Available color space formats will vary depending on the standards
supported by the selected output resolution.
5) ColorRange: Select the whether to output RGB with full range color
(0~255) or limited range color (16~235).
Note: Only valid when outputting using the RGB color space.
6) Audio LPCM: Set the number of LPCM audio channels to use when
outputting test tones.
Note: Will return to factory default settings if the power is turned off.
7) HDCP Out:
Select the HDCP version to encode the video signal with, or
disable HDCP.
Note: HDCP v2.2 is not supported in DVI mode.
8) HDCP Store K:
Enable or disable storing the HDCP master key from the
current display.
9) HDCP2 Rep. Type: Set the HDCP v2.2 repeater type compatibility
mode. Selecting 1 disables HDCP v2.2 authentication support in mixed
HDCP version environments (v2.2 & v1.4). Selecting 0 allows HDCP v2.2
content to be supported by HDCP v1.4 devices.
Note: Will return to factory default settings if the power is turned off.
10) GCP AV Mute: Enable or disable muting the video and audio output
using the GCP AV Mute setting.
Note: Will return to factory default settings if the power is turned off.
11) Output: Setting this to “Off” will completely disable the HDMI output,
including sync and 5V (if it is set to “Follow” mode).
Note: Will return to factory default settings if the power is turned off.
12) +5V Out: Configure the behavior of the 5V pin on the HDMI output.
Setting this to “Follow” will only send 5V when there is an active video
source. Setting this to “On” will force the 5V pin to always be active.