CYP CDPS-U42HPIP, Operation Manuals

Page: 9 / 48

4
button again to release the lock function. The LCD will display a
“Lock” message when the function is active.
10 PRESET: Press this button to switch between the “Preset Load” and
“Preset Save” modes. Pressing the button a 3rd time exits the Preset
menu.
A
Preset Save: When in “Preset Save” mode, pressing the “Enter”
button will save the currently displayed window layout.
B
Preset Load: When in the “Preset Load” mode, pressing the “Enter”
button will load the previously saved window layout.
Note: The audio selection is not saved as a part of the preset, only
the window layout.
11
LCD WINDOW: Displays the unit’s menu, settings, and information.
6.2 Rear Panel
DC 12V
CONTROL SERVICE
GN
D TX RX
RT
S
CT
S
COM
G
L/R OUT
-
+
-
+
A B
HDMI OUT
1 2 3 4
HDMI IN
1 2 4
3
5 6 7
1
HDMI IN 1~4: Connect to HDMI source equipment such as media
players, game consoles or set-top boxes. DVI source equipment
may be connected by using an HDMI to DVI adapter.
2
HDMI OUT A~B: Connect to HDMI TVs, monitors or amplifiers for
digital video and audio output. DVI display equipment may be
connected by using HDMI to DVI adapter.
3
L/R OUT: Connect to powered speakers or an amplifier using a 5-pin
adapter cable for balanced stereo analog audio output.
Note: Only LPCM 2.0 sources are supported. Bitstream audio
sources will be muted automatically.
4 COM: Connect directly to a PC, laptop or other serial control
device with a 3-pin adapter cable to send RS-232 commands to
control the unit.
5
CONTROL: Connect directly, or through a network switch, to your
PC/laptop to control the unit via Telnet/WebGUI.
6
SERVICE: This slot is reserved for firmware update use only.