Attach the light shielding film
Mount the light shielding film (enclosed documents) above the
touch buttons below the worktop. The purpose of the light
shielding film is to get the touch buttons to function optimally,
and to protect the worktop from moisture.
NOTE!
The surface on which the light shielding film is affixed must be
clean and dry.
Drainage connection
The dishwasher can pump out up to 20 l waste water per minute,
which the drain must be able to receive.
When the drainage hose is routed to a connection nipple on the
sink unit's water trap (see illustration 1), please note that the hose
must be attached at the same height as the underside of the sink
unit, otherwise dishwater from the sink may flow back into the
dishwasher. The drainage hose is threaded onto the cone-shaped
connection pipe on the sink unit's water trap. The cone-shaped
pipe must be cut to an internal diameter of at least 14 mm. For
other connection alternatives, see illustrations 2 and 3.
The drainage hose may be extended by a maximum of 3 m (the
total length of the drainage hose must not exceed 4,5 m). Any
joins and connecting pipes must have an internal diameter of at
least 14 mm. However, the drainage hose should ideally be re-
placed with a new hose without joins.
No part of the drainage hose may be more than 950 mm above
the bottom of the dishwasher. The hose must not be routed dir-
ectly to a floor drain or the like. In such cases, the hose can act
as a siphon and empty the dishwasher.
The hose must always discharge at least 350 mm above the
bottom of the machine.
Ensure that the drainage hose has no kinks.
NOTE!
The hose must be attached at the same height as the underside
of the sink.
Figure 1
Max. 950 mm
Min. 350 mm
Min. 14 mm
Max. 950 mm
Max. 3 m
Figure 2
Min. 350 mm
Figure 3
Max. 950 mm
Min. 350 mm
Connection to water supply
The dishwasher can be connected to hot and/or cold water. The
dishwasher adjusts automatically to the connected water in order
to achieve the best dishwashing result. To achieve optimal short
dishwashing time, the dishwasher should be connected to hot
water.
The water pressure must be between 0,03–1,0 MPa. To achieve
optimal short dishwashing time, the water pressure must be at
least 0,3 MPa.
60
-1
00
87
42
,5
[mm]
2
1
213
1
Connection for hot or cold water (Water connection: Single).
2
Connection for cold water when installing both hot and cold
water (Water connection: Mix). The connection must be
blocked with a plug when it is not being used.
Installation must be carried out by qualified professionals.
The supply pipe must be fitted with a stopcock. The stopcock
must be easily accessible, so that the water can be shut off if the
dishwasher has to be moved.
Use only the supply hoses supplied with the dishwasher. Do not
re-use old hoses or other loose supply hoses.
Once the installation is complete, the stopcock should be opened
to allow the pressure to settle for a while and to check that all
connections are tight.
Electrical connection
Information about the electrical connection can be found on the
serial number plate. This specification must match the electricity
supply.
47
EN
