Cylinda DM8330 FI, User Manual

Page: 34 / 44

NOTE!
Check that the coloured stop on
the right in the bottom drain is in
place.
Spray arms
Holes and bearings can sometimes become blocked. Re-
move any debris using a pin or the like. The spray arms
also have holes underneath.
To facilitate cleaning you can remove the spray arms. Re-
member to fit them firmly back into place afterwards.
Lower spray arm
• Pull the lower spray arm straight up to release it.
Upper spray arm
1. Pull out the upper basket.
2. Unscrew the spray arm bearings counterclockwise to
remove the spray arm from the upper basket.
The door and the door seal
Regularly clean the sides of the door and the door seal. Use
a slightly damp cloth (with a little cleaner if necessary).
Front panel
Keep the buttons clean and free from grease. Wipe them
clean with a dry or slightly damp cloth. Never use cleaners
– they can scratch the surface. Use the main power switch
to turn off the dishwasher before cleaning the buttons to
avoid activating any buttons unintentionally.
The dishwasher tub
The dishwasher tub is made of stainless steel and is kept
clean through normal use.
Limescale deposits
If you have hard water, limescale deposits may build up in
the dishwasher. If this happens, run a self-cleaning pro-
gramme with two tablespoons of citric acid in the detergent
compartment (with no dishes in the machine). See
Self-cleaning programme in the chapter Using the dishwash-
er.
Unblocking the drainage pump
If the dishwasher still contains water after the programme
has finished, something may be blocking the drainage pump.
Such items are easily removed.
1. Turn off the machine using the main power switch and
unplug it from the wall socket.
2. Remove the coarse filter and the fine filter.
3. Scoop out the water from the dishwasher tub.
4. In order to inspect the drainage pump, remove the col-
oured stop on the right in the bottom drain.
5. Turn the pump wheel located behind the drainage pump
stop by hand. Carefully remove any items.
6. Refit the drainage pump stop along with the fine and
coarse filters.
7. Plug the machine in again.
If the dishwasher still does not start and a whirring sound
is heard, the overflow protection has been activated.
•
Shut off the water.
•
Remove the plug from the wall socket.
•
Call the service department.
Drainage pump stop
NOTE!
Do not forget to refit the drainage pump stop.
34